The Model 45/90 Probe was introduced foruse with the Model PD Detector to provide ease of operating in pipe andcable locating, short location in corrosion control systems, and greatertracing distances.

To operate, connect the 45/90 Probe byinserting the plug into the receptacle labeled "Cleats" on the Receiverof the Model PD Detector. This operation automatically disconnects thesearch coil in the Receiver and the search coil of the probe is placedinto the circuit. A signal received by the search coil in the probe isamplified through the Receiver.

Operating of the 45/90 Probe is the sameas with the Model PD Receiver. (Refer to Operating Information for theModel PD Pearson Detector). When the search coil head is in a verticalposition, a sharp "null" will mark the center of the pipe, and when theprobe head is in a horizontal position, the pipe location is marked bya "peak" signal.

For determining depth, turn the probe,using the depth angle bubble into a 45 degrees angle position, move awayfrom the known pipe centerline with head 90 degrees to the pipe, and whena "null" is noted, mark the location. The distance from this location tothe pipe centerline is the depth.
 
 
 

SHIPPINGINSTRUCTIONS 

All instruments being returned for repair should be sent PREPAID to either address below: 

Ship Via Courrier (UPS, FedEx, DHL, etc)

Tinker & Rasor
ATTN: Repairs
791 S. Waterman Ave.
San Bernardino, CA 92408

Ship Via US Postal Mail

Tinker & Rasor
ATTN: Repairs
PO BOX 6890
San Bernardino, CA 92412-6890

Include with shipment information the nature of the problem, purchase order, serial number
and return delivery address, phone and fax numbers. Immediate service is guaranteed!